K 3500 Truck 4WD V8-6.6L DSL Turbo VIN 1 (2001)
Tailgate Release Handle: Service and Repair
End Gate Latch Handle Bezel
Removal and Installation
1. Release the adhesive blocks after the upper retaining tabs are released.
2. Install the latch handle bezel with the end gate in the closed position.
3. Clean the sheet metal at the right and left sides of the bezel opening with an alcohol wipe prior to the bezel installation.
4. Peel the protective tape liner from the foam block on both sides.
5. Seat the bezel at the bottom of the opening in the end gate.
6. Roll the bezel forward seating and securing the upper integral locking tabs.
7. Apply palm pressure to both outer edges of the bezel in order to wet out the adhesive foam blocks.
8. Integral Locking Tabs (Upper).
^
ENTRY Tip, gently pry downward with a small flat-bladed tool at the two locations in order to release the upper retaining tabs.
9. Integral Retention Tabs (Lower).
10. End Gate Latch Handle Bezel.
^
ENTRY Tip, once in position, gently wet out the adhesive foam blocks to the end gate panel.