K 3500 Truck 4WD V8-6.6L DSL Turbo VIN 1 (2001)
6.
Connect the WSS cable electrical connector.
7.
Install the brake rotor (2). Refer to Brake Rotor Replacement - Front in Disc Brakes.
8.
Install the tire and wheel. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
Wheel Speed Sensor Replacement (2WD) - 2001
Caution:
Refer to Brake Dust Caution in Cautions and Notices.
Removal Procedure
1.
Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
2.
Remove the tire and wheel. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
3.
Remove the brake rotor (2). Refer to Brake Rotor Replacement - Front in Disc Brakes.
4.
Remove the wheel speed sensor (WSS) mounting bolt.
Notice:
Carefully remove the sensor by pulling it straight out of the bore. DO NOT use a screwdriver, or other device to pry the sensor out of the bore.
Prying it will cause the sensor body to break oft in the bore.
5.
Remove the wheel speed sensor (5) from the hub/bearing assembly (4).
6.
Remove the WSS cable mounting clip from the knuckle.
7.
Remove the WSS cable mounting clip from the upper control arm.
8.
Remove the WSS cable mounting clip from the frame attachment point.
9.
Remove the WSS cable electrical connector.
Installation Procedure
