K 3500 Truck 4WD V8-6.6L DSL Turbo VIN 1 (2001)
6. Install the mounting bracket and brake caliper as an assembly.
Notice: Refer to Fastener Notice in Service Precautions.
7. Install the mounting bracket bolts.
^
Tighten the mounting bracket bolts to 300 Nm (221 ft. lbs.).
8. Tighten the brake caliper mounting bolts.
^
Tighten the brake caliper mounting bolts to 108 Nm (80 ft. lbs.).
9. Remove the rubber cap or plug from the exposed brake hose fitting end.
Important: Install NEW copper brake hose gaskets.
10. Assemble the NEW copper brake hose gaskets and the brake hose inlet fitting bolt to the brake hose.
11. Connect the brake hose at the caliper by installing the inlet fitting bolt.
^
Tighten the inlet fitting bolt to 45 Nm (33 ft. lbs.).
12. Bleed the hydraulic brake system.
13. Install the tire and wheel assembly.
14. Remove the safety stands.
15. Lower the vehicle.
16. Fill the master cylinder reservoir to the proper level with clean brake fluid.
