K 3500 Truck 4WD V8-6.6L DSL Turbo VIN 1 (2001)
9. Install the cable to the mounting bracket until the locking tabs snap into place.
Notice: Refer to Fastener Notice in Service Precautions.
10. Bolt the cable to the differential (clips).
^
Tighten the bolt to 25 Nm (18 ft. lbs.).
Important: After installing the cable to the rear axle holding clip, verify that clip is securely retaining the cable. If not, crimp the clip by hand taking
care not to pinch or kink the cable.
11. Install the cable to the differential clip.
12. Connect the cable to the equalizer.
13. Tighten the nut to the intermediate cable at the equalizer.
^
Tighten the nut to 3.5 Nm (31 inch lbs.).
14. Remove the safety stands.
15. Lower the vehicle.
16. Adjust the park brake cable.
