K 3500 Truck 4WD V8-6.6L DSL Turbo VIN 1 (2001)
Oil Level Sensor: Service and Repair
ENGINE OIL LEVEL SENSOR REPLACEMENT
REMOVAL PROCEDURE
1. Raise and suitably support the vehicle.
2. Remove the oil pan drain plug.
3. Completely drain the engine oil.
4. Disconnect the engine oil level sensor electrical connector.
5. Remove the engine oil level sensor.
INSTALLATION PROCEDURE
NOTE: Refer to Fastener Notice in Service Precautions.
1. Install the drain plug to the oil pan.
Tighten
Tighten the drain plug to 25 N.m (18 lb ft).
2. Install the engine oil level sensor.
Tighten
Tighten the engine oil level sensor to 13 N.m (115 lb in).
3. Connect the electrical connector to the engine oil sensor.
4. Lower the vehicle.
