K 3500 Truck 4WD V8-6.6L DSL Turbo VIN 1 (2001)
22.
Reinstall the air inlet grille panel center retainer and front edge retaining clips.
23.
Cycle the wipers to ensure the wiper system is in the parked position.
Important:
Inspect the windshield lower edge on each side. About 51-76 mm (2-3 in) from the bottom, you will find a 13 mm (1/2 in) long black mark
embedded in the glass. The black line is the position for the wiper blade to be in when the wiper system is in the parked position.
24.
Install the wiper arm assemblies. Position the wiper blades just below the black marks in the windshield.
25.
Install the retaining nuts.
Tighten
Tighten the retainers to 25 Nm (18 lb ft).
26.
Reconnect the washer hoses.
27.
Remove the fender covers.
28.
Close the hood.
Parts Information
Parts are currently available from GMSPO.
Warranty Information
For vehicles repaired under warranty use the table as shown.
DISCLAIMER
