K 3500 Truck 4WD V8-6.6L DSL Turbo VIN 1 (2001)
remover/installer center screw must be flat or the end of the shaft/axial plate assembly will be damaged.
3. Ensure that the center screw forces the tip to thrust against the end of the shaft.
4. Thread the J 33013-B into the hub.
5. While holding the body of J 33013-B of the remover with a wrench, turn the center screw into the remover body in order to remove the clutch
plate and hub assembly (1).
6. Remove the shaft key. Retain the shaft key for reassembly.
"For a description of the RPO Code(s) shown in this article or any of the images therein, refer to the RPO Code List found at Vehicle/Application ID".
See: Application and ID/RPO Codes
Compressor Clutch Plate/Hub Assembly Install (HT6/HD6/HU6)
TOOLS REQUIRED
J 33013-B Hub and Drive Plate Remover/Installer
1. Install the shaft key (4) into the hub key groove.
Allow the key to project approximately 3.2 mm (0.125 in) out of the keyway (3). The shaft key curves slightly in order to provide an interference
fit in the hub key groove.
2. Clean the following components:
-
The clutch plate
-
The clutch rotor (2)
3. Align the shaft key (4) with the shaft keyway (3).
4. Place the clutch plate and the hub assembly (1) onto the compressor shaft.
5. Remove the forcing tip on the J33013-B.
6. Reverse the body direction on the center screw.
