K 3500 Truck 4WD V8-6.6L DSL Turbo VIN 1 (2001)
1. Disconnect the negative battery cables from both batteries.
2. Remove the fuel tank cap.
3. Remove the clamps and rubber fuel hose from the fuel filter to the fuel injector control module (FICM) module.
INSTALLATION PROCEDURE
1. Install the hose and clamps.
2. Install the fuel tank cap.
3. Connect the negative battery cables to both batteries.
4. Prime the fuel system at the fuel manager 30 times to purge the air out of the hoses.
5. Start the engine and check for leaks.
Fuel System Priming
Fuel system priming procedures can be found under Fuel Delivery and Air Induction system service procedures. See: Powertrain Management/Fuel
Delivery and Air Induction/Service and Repair/Fuel System Priming
