K 3500 Truck 4WD V8-6.6L DSL Turbo VIN 1 (2001)
Engine Control Module: Service and Repair
Service Programming System (SPS)
Service Programming System (SPS)
The Service Programming System (SPS) allows a technician to program a control module through the Data Link Connector (DLC). The information
transfer circuit that is used at the DLC is the same serial data circuit used by the scan tool for retrieving Diagnostic Trouble Codes (DTCs), displaying
data, clearing DTCs, etc. This procedure offers the ability to install software/calibrations matched to a particular vehicle. This also allows one type of
control module to be used across different vehicle platforms and engine combinations. The following is a list of control modules that are programmable:
^
The Powertrain Control Module (PCM)
^
The Engine Control Module (ECM)
^
The Vehicle Control Module (VCM)
Types of Programmable Memory
EEPROM: Electrically erasable programmable read only memory - This type of memory allows selected portions of memory to be programmed while
other portions remain unchanged.
Certain learned values reside in EEPROM. The following information resides in EEPROM:
^
The vehicle identification number (VIN)
^
The crankshaft variation learned position
^
The software/calibrations identification numbers
^
The control module security information
Flash Memory: Flash read only memory - Flash memory has increased memory storage capacity. During programming, all information within memory
is erased, and then replaced with entirely new information.
Most control modules have both types of memory. The software/calibrations reside in the flash memory.
Service Programming Methods
Service Programming Methods
The three methods of programming a control module and the proper tools for each method are as follows:
^
Remote Programming:
-
The Tech 2 and the Techline Terminal
-
The control module installed in the vehicle
^
Pass Through Programming:
-
The Tech 2 or other scan tools, Techline Terminal or a personal computer equipped with General Motors Corporation authorized programming
software - The Tech 2 or other scan tools are used as an interface between the vehicle and the Techline Terminal or a personal computer.
-
The control module installed in the vehicle.
^
Off-Board Programming (Vehicle NOT available):
-
The Tech 2, Techline Terminal, and Off Board Programming Adapter
-
The control module NOT installed in a vehicle
Before Programming A Control Module
IMPORTANT: Do NOT program an existing control module with the identical software/calibration package. This procedure is not a short cut to
correct a driveability condition. This is an ineffective repair. A control module should only be programmed when the following occurs:
^
When a service procedure instructs you to replace the control module. The service part control module does not contain operating software or
calibrations.
^
General Motors Corporation releases an updated software/calibration package.
Ensure the following conditions are met before programming a control module:
^
Vehicle system voltage:
-
There is no charging system concern. All charging system concerns must be repaired before programming a control module.
-
Battery voltage is greater than 12 volts but less than 16 volts. The battery must be charged before programming the control module if the
battery voltage is low.
-
A battery charger is NOT connected to the vehicles battery. Incorrect system voltage or voltage fluctuations from a battery charger, may cause
programming failure or control module damage.
-
Turn OFF or disable any system that may put a load on the vehicles battery.
^
Daytime running lights (DRL). Applying the parking brake, on most vehicles, disables the DRL system.
^
Heating, ventilation, and air conditioning (HVAC) systems
^
Cooling System fans, etc.
^
The ignition switch is in the proper position. The scan tool prompts you to turn ON the ignition, with the engine OFF. Do NOT change the position
of the ignition switch during the programming procedure, unless instructed to do so.
^
All tool connections are secure:
