K 3500 Truck 4WD V8-6.6L DSL Turbo VIN 1 (2001)
9.
Remove and discard the neutral assurance bracket.
Important:
Installation of the front shield and rear shields are important. Without proper installation of the shield, a return repair is probable. Follow all
directions as listed on the installation instructions sheet included in the Switch kit, P/N 29540479.
10.
Fit the new shield onto the PNP switch so that it fits securely against the switch. Make sure this is done before reinstalling the shift lever.
11.
Reinstall the shift lever. With a wrench keeping the shift lever from rotating, install the nut on the end of the selector shaft.
Tighten.
Tighten the nut to 24 N.m (18 lb ft).
12.
Connect the wiring harness connectors to the PNP switch.
13.
Attach the selector cable to the lever. Check and adjust if needed.
14.
Go back to step 4 of the Diagnostics and insure the Tech 2 readings match the shift lever positions.
Important:
Clear all DTCs before returning the vehicle to the customer.
15.
Return the vehicle to the customer.
