K 3500 Truck 4WD V8-6.6L DSL Turbo VIN 1 (2001)
9. Disconnect the electronic brake control module mounting bracket (3) from the frame rail (5).
10. Allow the electronic brake control module to remain loose in order to allow fuel pipe clearance.
11. Remove the fuel bundle (3) using the following procedure:
11.1. Guide the fuel bundle (2) pipes towards the rear of vehicle to clear the engine.
11.2. Lower the fuel bundle while moving it forward and out.
NOTE: Refer to Nylon Fuel Lines Notice in Service Precautions.
12. If replacing an individual fuel pipe, remove the pipe from the retaining clips.
INSTALLATION PROCEDURE
1. If replacing an individual fuel pipe, place the new fuel pipe in the retaining clips.
2. Install the fuel bundle (3) to the chassis (1) using the following procedure:
2.1. Install the fuel bundle (3) to the chassis by guiding the pipes towards the rear of vehicle.
2.2. Lift the fuel pipes, while guiding the forward portion of the pipes up towards the engine connections.
NOTE: Refer to Fastener Notice in Service Precautions.
3. Attach the fuel bundle to the chassis.
Tighten
Tighten the fuel bundle retaining nuts (1) to 16 N.m (12 lb ft).
4. Remove the fuel caps.
5. Install the system cooler.
