K 3500 Truck 4WD V8-6.6L DSL Turbo VIN 1 (2001)
12. Loosen the charged air cooler inlet duct to charged air cooler clamp.
13. Remove the charged air cooler inlet hose and pipe assembly from the vehicle. The assembly can be removed as one piece with the left front fender
wheelhouse inner panel removed.
14. Disassemble the hose and pipe assembly as required.
15. Inspect the hoses for cuts or tears.
16. Inspect the pipes for damage.
17. Replace the hose or pipe if damage is found.
Installation Procedure
1. Install the charged air cooler inlet hose to the pipe. The hose is marked for correct installation.
2. Install the hose clamps on the charged air cooler inlet hose but do not tighten.
3. Install the charged air cooler inlet hose to the charged air cooler aligning the marks on the hoses.
