K 3500 Truck 4WD V8-6.6L DSL Turbo VIN 1 (2001)
1. Install the motor encoder gasket to the transfer case.
Important: When installing the motor encoder unit to the transfer case, make sure that the transfer case is indexed properly and is flat against the
transfer case before tightening the mounting bolts.
2. Install the motor encoder to the transfer case.
Notice: Refer to Fastener Notice in Service Precautions.
3. Install the motor encoder mounting bolts.
^
Tighten the motor encoder bolts to 20 Nm (15 ft. lbs.).
4. Install the motor encoder electrical connector. Ensure that the retention clips activate.
5. Install the front propeller shaft.
6. Install the transfer case shield.
7. Lower the vehicle. Refer to Vehicle Lifting.
