K 3500 Truck 4WD V8-6.6L DSL Turbo VIN 1 (2001)
1. Move the electrical harness to the left side in order to make room to install the transfer case shift control module.
2. Install the transfer case shift control module so that the electrical connector ports are to the right or pointing towards the instrument cluster.
3. While installing the transfer case shift control module rotate clockwise until the module is in place and the electrical connector ports are facing
outwards.
4. Install the electrical harness retainer to the IP support beam.
5. Connect the 2 electrical connectors to the transfer case shift control module.
6. Install the lamp switch, 4WD shift buttons, cargo lamp and air deflector louver assembly the vehicle.
7. Connect all the electrical connectors to the lamp switch, cargo lamp and 4WD shift buttons assembly.
8. Install the lamp switch, 4WD shift buttons, cargo lamp and air deflector louver assembly in place.
9. Install the IP trim bezel.
10. Start the engine and test the automatic transfer case system for proper shift operation.
