K 3500 Truck 4WD V8-6.6L DSL Turbo VIN 1 (2001)
29. Route the deployment harness out of the vehicle's driver side.
30. Disconnect the inflatable restraint IP module connector (1) located behind the glove box (3).
31. Cut the IP module harness connector out of the vehicle, leaving at least 16 cm (6 in) of wire at the connector.
32. Strip 13 mm (0.5 in) of insulation from each of the connector wire leads.
33. Cut 26.1 m (20 ft) deployment wires from a 0.8 mm (18 gage) or thicker multi-strand wire. These wires will be used to fabricate the deployment
