K 3500 Truck 4WD V8-6.6L DSL Turbo VIN 1 (2001)
3.
Remove the brake rotor (2). Refer to Brake Rotor Replacement - Front in Disc Brakes.
4.
Remove the wheel speed sensor (WSS) mounting bolt.
Notice:
Carefully remove the sensor by pulling it straight out of the bore. DO NOT use a screwdriver, or other device to pry the sensor out of the bore.
Prying it will cause the sensor body to break oft in the bore.
5.
Remove the wheel speed sensor (5) from the hub/bearing assembly (4).
6.
Remove the WSS cable mounting clip from the knuckle.
7.
Remove the WSS cable mounting clip from the upper control arm.
8.
Remove the WSS cable mounting clip from the frame attachment point.
9.
Remove the WSS cable electrical connector.
Installation Procedure
1.
Install the WSS (5) into the hub/bearing assembly (4).
Notice:
Refer to Fastener Notice in Cautions and Notices.
2.
Install the WSS mounting bolt.
Tighten
Tighten the WSS mounting bolt to 18 N.m (13 lb ft).
3.
Install the WSS cable mounting clip to the knuckle.
