K 3500 Truck 4WD V8-6.6L DSL Turbo VIN 1 (2001)
Installation Procedure
1.
Install the WSS (5) into the hub/bearing assembly (4).
Notice:
Refer to Fastener Notice in Cautions and Notices.
2.
Install the WSS mounting bolt.
Tighten
Tighten the WSS mounting bolt to 18 N.m (13 lb ft).
3.
Install the WSS cable mounting clip to the knuckle.
4.
Install the WSS cable mounting clip to the upper control arm.
5.
Install the WSS cable mounting clip to the frame attachment point.
6.
Connect the WSS cable electrical connector.
7.
Install the brake rotor (2). Refer to Brake Rotor Replacement - Front in Disc Brakes.
8.
Install the tire and wheel. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
Wheel Speed Sensor Replacement (S4WD) - 1999 - 2000
Caution:
Refer to Brake Dust Caution in Cautions and Notices.
Removal Procedure
1.
Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
2.
Remove the tire and wheel. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
