K 3500 Truck 4WD V8-6.6L DSL Turbo VIN 1 (2001)
IMPORTANT: Identify the type of steering wheel position sensor from the illustrations below BEFORE removing the sensor from the steering
column. Once you have identified the steering wheel position sensor, follow the instructions listed in the removal procedure.
1. Verify the type of steering wheel position sensor.
2. From the technicians point of view, the FRONT of the sensor (1) connector will be on the right.
IMPORTANT: If reusing the existing sensor, you do not have to align the sensor before removal. Centering is not required when it is time to
reinstall.
3. Remove the connector from the sensor.
4. Remove the sensor (1) from the adapter and bearing assembly.
5. To install the sensor, proceed to step 1 in the installation section.
6. From the technicians point of view, the FRONT of the sensor will have:
^
A foam ring (2)
^
A pin hole (1) for centering the pin (note location of the pin hole)
^
A flush rotor flange cuff (4)
IMPORTANT: If reusing the existing sensor, you must make an alignment mark on the rotor flange cuff (3) before removing the sensor. Failure
to do so will cause misalignment when installing the sensor. A new sensor will be required if misaligned.
7. Make an alignment mark on the flush rotor flange cuff (3).
8. Remove the connector from the sensor.
9. Remove the sensor from the adapter and bearing assembly.
10. To install the sensor, proceed to step 5 in the installation section.
11. From the technicians point of view, the FRONT of the sensor will have:
^
A raised rotor flange cuff (3)
