K 3500 Truck 4WD V8-6.6L DSL Turbo VIN 1 (2001)
3. Install the new O-ring seals (1) to the valve end of the cylinder lines.
Notice: Refer to Fastener Notice in Service Precautions.
4. Install the cylinder line assemblies (1) to the gear assembly (2).
-
Tighten the valve end fittings to 16.9 Nm (12.6 ft. lbs.)
-
Tighten the cylinder end fittings to 27 Nm (20 ft. lbs.)
Steering Gear Stub Shaft Seals and Bearing Replacement
-
Tools Required
-
J 6222-A Stub Shaft Seal Protector
Disassembly Procedure
1. Remove the adjuster plug lock nut (5) from the adjuster plug (4).
2. Remove the adjuster plug (4) from the gear assembly (1).
3. Remove the adjuster spring (3) and the rack bearing (2).
