K 3500 Truck 4WD V8-6.6L DSL Turbo VIN 1 (2001)
2. Coat the double lip seal (2) and the washer (3) with grease.
3. Install the double lip seal (2).
4. Install the backup washer (3).
5. Install the retaining ring using the J 4245.
Important: Do not install the lock washer and nut until complete installation of the pitman arm and it's components have been installed. Do not
adjust the pitman shaft until all components have been installed on the the steering gear housing.
6. Install the pitman shaft and the side cover. Refer to Steering Gear Pitman Shaft and Housing Cover Replacement - Off Vehicle.
7. Install the dust seal (1).
8. Install the pitman shaft boot (2).
9. Install the pitman arm (3) to the steering gear (1).
10. Install the lock washer (4).
