K 3500 Truck 4WD V8-6.6L DSL Turbo VIN 1 (2001)
Suspension Strut / Shock Absorber: Service and Repair
Rear Shock Absorber
Shock Absorber Replacement
Removal Procedure
1. Raise and support the vehicle. Refer to Vehicle Lifting.
2. Disconnect the electrical connector if equipped with Selectable Ride.
3. Remove the upper shock absorber nut and the bolt.
4. Remove the lower shock absorber nut and the bolt.
5. Remove the shock absorber.
Installation Procedure
1. Install the shock absorber.
2. Install the upper shock absorber nut and bolt.
Notice: Refer to Fastener Notice in Service Precautions.
3. Install the lower shock absorber nut and bolt.
-
Tighten the nuts to 95 Nm (70 ft. lbs.).
4. Connect the electrical connector if equipped with Selectable Ride.
5. Remove the safety stands.
6. Lower the vehicle.
Shock Absorber Disposal
Caution: Gas charged shock absorbers contain high pressure gas. Do not remove the snap ring from inside the top of the tube. If the snap
ring is removed, the contents of the shock absorber will come out with extreme force which may result in personal injury.
