K 3500 Truck 4WD V8-6.6L DSL Turbo VIN 1 (2001)
2. install the torsion bar crossmember.
Notice: Refer to Fastener Notice in Service Precautions.
3. Install the torsion bar crossmember bolts (1) to the weld nuts (4).
^
Tighten the bolt to 95 Nm (70 ft. lbs.).
4. Install the upper link mounting nuts and the bolts (3). (K 25/35 Series with MT1, MW3, C5F and COP).
^
Tighten the nut to 95 Nm (70 ft. lbs.).
5. While supporting the adjustment arm, slide the torsion bar rearward until the torsion bar fully engages the adjustment arm.
6. Install the J 36202 to the adjustment arm and the crossmember.
7. Increase the tension on the adjustment arm in order to load the torsion bar.
