K 3500 Truck 4WD V8-6.6L DSL Turbo VIN 1 (2001)
Clutch Slave Cylinder: Service and Repair
Concentric Slave Cylinder (NV 3500 and NV 4500)
Concentric Slave Cylinder (NV 3500 and NV 4500)
Removal Procedure
1. Remove the transmission.
2. Remove the 2 bolts securing the actuator cylinder to the clutch housing.
3. Remove the actuator cylinder from the transmission input shaft. If required, the bearing can be removed from the actuator cylinder for
replacement.
Installation Procedure
1. Position the actuator cylinder to the transmission input shaft.
Ensure that the bleed screw and the coupling are positioned toward the transmission ports,
Notice: Refer to Fastener Notice in Service Precautions.
2. Secure the actuator cylinder to the clutch housing with 2 bolts.
^
Tighten the bolts to 8 Nm (71 inch lbs.).
3. Install the transmission.
