K 3500 Truck 4WD V8-6.6L DSL Turbo VIN 1 (2001)
Clutch Slave Cylinder: Service and Repair
Concentric Slave Cylinder (ZF S6-650)
Concentric Slave Cylinder (ZF S6-650)
Removal Procedure
1. Remove the transmission.
2. Remove the 2 bolts securing the actuator cylinder to the clutch housing.
3. Quick disconnect the hydraulic line from the concentric slave cylinder.
4. Remove the actuator cylinder from the transmission input shaft.
If required, the bearing can be removed from the actuator cylinder for replacement.
Installation Procedure
1. Position the actuator cylinder to the transmission input shaft.
Quick connect the hydraulic line to the concentric slave cylinder.
Notice: Refer to Fastener Notice in Service Precautions.
2. Secure the actuator cylinder to the clutch housing with 2 bolts.
^
Tighten the bolts to 8 Nm (71 inch lbs.).
3. Install the transmission.
