K 3500 Truck 4WD V8-6.6L DSL Turbo VIN 1 (2001)
70.
Replace the pump outer 0-ring seal (6).
71.
Place a thin coating of TransJel(TM), or equivalent, to the flange of the support assembly and the thrust washer. Then install the thrust washer,
properly aligning the retaining tabs.
Note:
Interchanging the ground sleeve sealing rings with the wrong part number seal ring on the ground sleeve (stator shaft) may result in
transmission damage. Install the correct seal ring.
Important:
The seal rings (6) may be either a butt-type or an overlap style. The service kit comes with both types. Replace the seal rings with the same
type as those removed.
72.
Install three new seal rings (6) with the correct part number to the hub of the support assembly.
73.
Turn the pump and support assembly over and install one P/N 29536406 (2) into the middle groove of the ground sleeve (3).
74.
Install one P/N 29536405 (1) seal ring into the top groove of the ground sleeve (3).
