K 3500 Truck 4WD V8-6.6L DSL Turbo VIN 1 (2001)
52.
Remove the inner ring often (10) bolts (1) from the converter housing.
53.
Remove and discard the seals (2) from under the heads of the ten (10) bolts (1) you just removed.
54.
Using a wooden block or hammer handle and another hammer, separate the front support and pump from the housing by placing the wooden block
or hammer handle on the bosses of the front pump/support module and tapping on the wooden block or hammer, alternating from position to
position in a star pattern.
Important:
The seal rings (6) may be either a butt-type or an overlap style. The service kit comes with both types. Replace the seal rings with the same
type as those removed.
55.
Remove the two seal rings (1 and 2) from the ground sleeve and the three seal rings (6) and thrust washer (5) from the rear hub of the support
assembly.
