K 3500 Truck 4WD V8-6.6L DSL Turbo VIN 1 (2001)
4. Check the gap dimension on the clamp ear. Continue tightening until the gap dimension is reached.
Important: Assemble the CV joint with the convolute retainer in the correct position, as illustrated.
5. Install the convolute retainer over the inboard joint seal, being sure to capture three convolutions.
6. Install the tri-pot spider assembly (3) onto the halfshaft bar (2) with the counterbore towards the end of the halfshaft bar (2).
7. Install the spacer ring (1) in the groove at the end of the halfshaft bar (2).
8. Push the spider assembly (1) back toward the end of the halfshaft bar (2) until the spacer ring is covered by the spider assembly (1) counterbore.
