K 3500 Truck 4WD V8-6.6L DSL Turbo VIN 1 (2001)
9. Pack the tri-pot seal (4) and the tri-pot housing (1) with the grease supplied in the kit. The amount of grease supplied in this kit has been
pre-measured for this application.
10. Reassemble the tri-pot housing and the tri-pot seal using the following procedure:
10.1.
Pinch the swage ring (2) slightly by hand in order to distort it into an oval shape.
10.2.
Slide the distorted swage ring (2) over the large diameter of the seal.
10.3.
Place the tri-pot housing over the spider assembly.
10.4.
Install the seal onto the tri-pot housing.
10.5.
Align the tri-pot seal (1), with the swage ring (2) in place, over the flat area on the tri-pot housing (3).
11. Mount J 36652 in a vise.
12. Install the bottom half of the split-plate swage clamp. For K1 5 models, use J 36652-98.
13. For K25 models, use J 36652-1.
