K 3500 Truck 4WD V8-6.6L DSL Turbo VIN 1 (2001)
1. Position the retainer and shift boot onto the shift lever.
Notice: Refer to Fastener Notice in Service Precautions.
2. Install 8 screws securing the shift boot and insulator to the floor panel.
^
Tighten the screws to 2 Nm (18 inch lbs.).
3. Install 4 plastic retainer plugs securing the shift boot retainer to the shift boot.
4. Install the shift lever to the shift tower. If required, use the shift lever adjusting nut to center the shift lever.
^
Tighten the shift lever nut to 47 Nm (35 ft. lbs.).
Shift Tower Replacement
Shift Tower Replacement
Removal Procedure
Important:
^
Ensure that the shift lever is positioned into the mechanical third or fourth gear prior to removal of the shift housing from the transmission. The
transmission must remain in this state when the shift housing is removed.
^
Do not disassemble the transmission shift housing. Internal parts for this shift housing are not available. Opening the shift housing voids the
warranty.
^
When removing the shift housing from the transmission, use the exposed bolts on the base of the housing.
