K Yukon/Denali 4WD V8-5.7L VIN R (2000)
Rear Door Exterior Handle: Service and Repair
Door Handle Components
Lock Rod and Outside Handle Replace - Rear Door
Removal Procedure
1. Remove the trim panel, as necessary.
2. Remove the water deflector, as necessary.
3. Remove the access hole cover, as necessary.
4. Disconnect the lock cylinder rod from the rod clip.
5. Disconnect the outside handle rod from the rod clip.
6. Remove the outside handle mounting bolts.
7. Remove the outside handle assembly.
8. Remove the door lock cylinder from the outside handle housing.
9. Complete the necessary procedures:
*
For repair of a binding lock cylinder. Refer to Lock Cylinder Binding in Doors.
*
For coding a new lock cylinder, Refer to Key and Lock Cylinder Coding.
Installation Procedure
1. When installing a new lock cylinder, apply GM P/N 12345120 lubricant or a similar lubricant to the inside of the lock case and the cylinder
keyway.
2. Install the door lock cylinder to the outside handle housing.
3. Install the handle assembly.
Notice: Refer to Fastener Notice in Service Precautions.
4. Install the outside handle mounting bolts.
Tighten the bolts to 4 N.m (35 lb in).
5. Connect the outside handle rod to the rod clip.
6. Connect the lock cylinder rod to the rod clip.
7. Install the access hole cover, as necessary.
8. Install the water deflector, as necessary.
