K Yukon/Denali 4WD V8-5.7L VIN R (2000)
Air Bag(s) Arming and Disarming: Service and Repair
Enabling
1. Remove the key from the ignition switch.
2. Connect the passenger yellow 2-way connector (1) located near the base of the steering column.
3. Install the Connector Position Assurance (CPA) (2) to the passenger yellow 2-way connector located near the base of the steering column.
4. Connect the driver yellow 2-way connector (2) located at the base of the steering column.
5. Install the Connector Position Assurance (CPA) (1) to the driver yellow 2-way connector located at the base of the steering column.
6. Install the AIR BAG Fuse to the IP fuse block.
7. Staying well away from the air bags, turn ON the ignition.
7.1.
The AIR BAG warning lamp will flash 7 times.
7.2.
The AIR BAG warning lamp will then turn OFF.
8. Perform the Diagnostic System Check - SIR if the AIR BAG warning lamp does not operate as described. Refer to A Diagnostic System Check -
SIR.
