K Yukon/Denali 4WD V8-5.7L VIN R (2000)
1. Install the quarter panel trim to the vehicle.
Notice: Refer to Fastener Notice in Service Precautions.
2. Install the quarter panel trim screws.
Tighten the quarter panel trim screws to 2 N.m (18 lb in).
3. Install the front door lock pillar molding to the pillar.
4. Install the cargo door pillar molding to the pillar.
5. Install the rear blower motor trim cover.
6. Install the rear seat.
Rear Upper Garnish Molding Replacement (Tahoe/Yukon/Escalade/Suburban)
Rear Upper Garnish Molding Replacement (Tahoe/Yukon/Escalade/Suburban)
Tools Required
J 38778 Door Trim Pad Clip Remover
Removal Procedure
1. Use the J 38778 in order to remove the rear upper garnish molding.
Insert the J 38778 and work along the front edge of the trim panel from one end to the other.
2. Remove the rear upper garnish molding from the vehicle.
Installation Procedure
Install the roof rear upper garnish molding to the vehicle until it clicks into place.
Rear Window Lower Garnish Molding Replacement