K Yukon/Denali 4WD V8-5.7L VIN R (2000)
7. Remove the seat back frame (13) from the seat assembly.
Installation Procedure
1. If the seat is equipped with a lumbar support, complete the following steps:
1. Insert the lumbar adjuster cable into the slot in the assembly. Turn the threaded black end of the assembly until the slot retaining the cable is
concealed.
2. Install the 2 screws retaining the lumbar cable assembly to the seat cushion frame.
3. Install the seat cushion pad.
Notice: Refer to Fastener Notice in Service Precautions.
Important: Install the bolts to the original locations.
2. Install the 2 bolts retaining the seat back recliner to the seat back frame (13).
Tighten the bolts to 30 N.m (22 lb ft).
3. Install the 2 bolts retaining the seat back hinge to the seat back frame.
Tighten the bolts to 30 N.m (22 lb ft).
4. Install the seat back pad (12).
5. Install the headrest (1) and the guides (2).
6. Install the seat to the riser.
Front Seat Back Frame Replacement (Split Bench)
Front Seat Back Frame Replacement (Split Bench)
Removal Procedure
1. Remove the seat from the riser.
2. Remove the headrest and guides.
3. Remove the seat back pad.
Important: Note the position and the length of the bolts removed.
