K Yukon/Denali 4WD V8-5.7L VIN R (2000)
Wheel Speed Sensor: Service and Repair
Wheel Speed Sensor Bracket Replacement - Front
Removal Procedure
Notice: Whenever performing repairs to the wheel speed sensor, wheel speed sensor mounting bracket, steering arm, front caliper anchor plate,
steering knuckle, inner bearing dust shield or any attaching fasteners, the wheel speed sensor air gap may be moved out of adjustment. Ensure proper
wheel speed sensor air gap to prevent damage to the wheel speed sensor and to insure the proper operation of the antilock brake system.
1. Raise vehicle.
2. Remove tire and wheel. Refer to Tire and Wheel Removal and Installation.
3. Remove the hub and rotor. Refer to Wheel Hub, Bearing, and Seal Replacement (S4WD).
4. Remove wheel speed sensor to bracket mounting nuts and bolts (6).
5. Remove wheel speed sensor (3) from mounting bracket (4).
6. Remove wheel speed sensor to mounting bracket attaching nuts (5).
7. Remove wheel speed sensor mounting bracket (4).
Installation Procedure
1. Install wheel speed sensor mounting bracket (4).
Notice: Refer to Fastener Notice, in Service Precautions.
Important: Do not install washers between the attaching nuts and the wheel speed sensor mounting bracket, or insufficient thread engagement may
occur.
2. Install wheel speed sensor mounting bracket attaching nuts (6).
^
Tighten the attaching nuts to 285 Nm (210 ft. lbs.).
3. Install and adjust wheel speed sensor to mounting bracket. Refer to Wheel Speed Sensor Replacement (C3500 HD).
