K Yukon/Denali 4WD V8-5.7L VIN R (2000)
4. Drive the support key in place using a brass punch and a hammer.
Notice: Refer to Fastener Notice in Service Precautions.
5. Install the bolt (2). The boss on the bolt must fit into the circular cutout in the key.
^
Tighten the bolt to 20 Nm (15 ft. lbs.).
6. Install the brake hose.
Notice: Make sure the brake hose is not twisted or kinked after installation. Damage to the hose could result.
^
Tighten the brake hose to 45 Nm (33 ft. lbs.).
7. Bleed the system. Refer to Hydraulic Brake System Bleeding.
8. Install the tire and the wheel assembly. Refer to Tire and Wheel Removal and Installation.
Important: Pump the brake pedal until it is firm before moving the vehicle. Check the brake fluid level in the master cylinder after pumping the
brakes.
9. Lower the vehicle.
Delco Brakes
Removal Procedure
