K Yukon/Denali 4WD V8-5.7L VIN R (2000)
1. Remove two-thirds of the brake fluid from the master cylinder.
2. Raise the vehicle. Support the vehicle with suitable safety stands. Refer to Vehicle Lifting.
3. Mark the relationship between the wheel and the hub.
4. Remove the tire and the wheel. Refer to Tire and Wheel Removal and Installation.
5. Position a C-clamp and tighten until the piston bottoms in the bore.
6. Remove the C-clamp.
7. Remove the brake hose.
8. Remove the bolt (2).
9. Remove the support key and the spring using a brass punch and a hammer to drive out the support key.
10. Remove the caliper assembly.
11. Inspect the inside of the caliper assembly for signs of fluid leakage. Refer to Brake Caliper Overhaul if any leakage is detected.
12. Use a wire brush to remove any corrosion from the machined surfaces of the anchor plate and the caliper.
Installation Procedure
