K Yukon/Denali 4WD V8-5.7L VIN R (2000)
Important: After installation, the brake hose must not be twisted. The brake hose must not contact any other components.
1. Install the brake hose. Ensure the hose in not twisted.
2. Install the new copper washers.
Notice: Refer to Fastener Notice in Service Precautions.
3. Install the bolt.
^
Tighten the bolt to 44 Nm (32 ft. lbs.).
4. Install the clip.
5. Connect the steel pipe. Refer to Brake Pipe Replacement.
6. Bleed the brakes. Refer to Hydraulic Brake System Bleeding.
