K Yukon/Denali 4WD V8-5.7L VIN R (2000)
Parking Brake Cable: Service and Repair
Park Brake Cable Replacement - Rear (Except C3500HD)
Removal Procedure
1. Release the park brake.
2. Raise the vehicle and support the vehicle with safety stands. Refer to Vehicle Lifting.
3. Loosen the nut at the equalizer.
4. Remove the connector.
5. Disconnect the rear brake assembly. Refer to Brake Drum Replacement.
6. Bend the retaining fingers at the backing plate.
7. Disconnect the cable.
Installation Procedure
1. Install the cable.
2. Connect the cable end into the backing plate. Make sure all retaining fingers are completely through the backing plate.
3. Connect the rear brake assembly. Refer to Brake Drum Replacement.
4. Install the connector.
5. Adjust the rear cable. Refer to Park Brake Cable Service/Adjustment.
