K Yukon/Denali 4WD V8-5.7L VIN R (2000)
Parking Brake Warning Switch: Service and Repair
Removal Procedure
Caution: Before servicing any electrical component, the ignition key must be in the OFF or LOCK position and all electrical loads must be
OFF, unless instructed otherwise in these procedures. If a tool or equipment could easily come in contact with a live exposed electrical
terminal, also disconnect the negative battery cable. Failure to follow these precautions may cause personal injury and/or damage to the
vehicle or its components.
1. Remove the electrical connector.
2. Remove the retainer from the switch.
3. Remove the park brake indicator switch from the vehicle.
Installation Procedure
1. Connect the park brake indicator switch to the vehicle.
2. Connect the retainer to the switch.
Notice: Refer to Fastener Notice in Service Precautions.
3. Install the retaining screw.
^
Tighten the retaining screw to 4 Nm (35 inch lbs.).
4. Install the electrical connector.
