K Yukon/Denali 4WD V8-5.7L VIN R (2000)
Vehicle Speed Sensor: Service and Repair
NVG 243-NP1 (Two Speed Selectable)
Removal Procedure
1. Remove the two electrical connectors from the two rear speed sensors.
2. Remove the two rear speed sensors from the transfer case.
Installation Procedure
Notice: Refer to Fastener Notice in Service Precautions.
1. Install the two rear speed sensors to the transfer case.
Tighten the rear speed sensors to 31 Nm (23 ft. lbs.).
2. Install the two electrical connectors to the two rear speed sensors.
