K Yukon/Denali 4WD V8-5.7L VIN R (2000)
Vehicle Speed Sensor: Service and Repair
4L60-E Transmission
Removal Procedure
^
Required Tools
-
J38417 Speed Sensor Remover
1. Remove the harness connector.
2. Remove the bolt.
3. Remove the vehicle speed sensor using J38417. Have a suitable container in order to catch the fluid.
4. Remove the O-ring seal.
Installation Procedure
^
Required Tools
-
J38417 Speed Sensor Remover
1. Install the new speed sensor and O-ring seal using J38417.
2. Coat the seal with a thin film of transmission fluid.
Notice: Refer to Fastener Notice in Service Precautions.
3. Install the bolt.
Tighten the bolt to 11 Nm (97 inch lbs.).
4. Install the harness connector.
5. Refill the fluid as required. Refer to Fluid Capacity.
