K Yukon/Denali 4WD V8-5.7L VIN R (2000)
1. Install the ignition coil to the bracket with the two screws.
NOTE: Refer to Fastener Notice in Service Precautions.
2. Install the ignition coil and the bracket to the intake manifold with studs.
Tighten
Tighten the studs to 11 N.m (8 lb ft).
3. Install the ignition coil wire.
The wire must not touch anything like the dip stick. Rubbing will make a ground/short after time of use.
4. Install the electrical connectors.
