K Yukon/Denali 4WD V8-5.7L VIN R (2000)
9.7.
Install a new fastener GM IP/N 11515933.
INSTALLATION PROCEDURE
1. Install the SDM (3) to the vehicle.
NOTE: Refer to Fastener Notice in Service Precautions.
2. Install the SDM mounting fasteners.
Tighten
Tighten fasteners to 12 N.m (106 lb in).
3. Install the SDM harness connector (1) to the SDM.
4. Install the connector position assurance (2) to the SDM harness connector.
5. Position the carpet to cover the inflatable restraint Sensing and Diagnostic Module (SDM).
6. Install the carpet retaining sill trim molding - LH.
7. Install the driver seat.
8. Enable the SIR system. Refer to Enabling the SIR System.