K Yukon/Denali 4WD V8-5.7L VIN R (2000)
Power Seat Switch: Service and Repair
Lumbar Switch Replacement (Power)
Lumbar Switch Replacement (Power)
Removal Procedure
1. Remove the screws attached to the side of the seat cushion.
2. Pull the switch partially out from the seat cushion.
3. Remove the switch from the switch bezel.
4. Remove the switch wiring harness in-line connector.
5. Remove the switch and the wiring harness from the side of the seat cushion.
Installation Procedure
1. Route the switch wiring harness through the opening in the side of the seat cushion and through the opening in the seat frame.
2. Install the switch wiring harness to the vehicle wiring harness.
3. Install the switch wiring harness in-line connector.
4. Install the switch in the switch bezel.
Position the switch bezel in the seat cushion opening.
5. Install the screws.
