K Yukon/Denali 4WD V8-5.7L VIN R (2000)
3. Install the relay rod (10) to the idler arm ball stud. Make sure the seal is on the stud.
-
Tighten the J 29193 or the J 29194 to 54 Nm (40 ft. lbs.) in order to seat the tapers.
4. Remove the tool.
5. Install the new prevailing torque nut to the idler arm ball stud.
-
Tighten the nut to 62 Nm (46 ft. lbs.).
6. Lower the vehicle.
7. Adjust the front toe. Refer to Measuring Wheel Alignment in Wheel Alignment.
