K Yukon/Denali 4WD V8-5.7L VIN R (2000)
Assembly Procedure
Important: Use new O-ring seals when assembling the power steering pump assembly.
1. Lubricate the O-ring seals (1) (4) with power steering fluid.
2. Install the O-ring seals (1) (4) to the pump housing assembly (2).
3. Install the magnet (3) to the pump housing assembly (2).
4. Connect the reservoir assembly (1) to the pump housing assembly (2).
5. Install the O-ring seal.
6. Install the connector and fitting assembly (5). To install the variable assist steering actuator (3) and retaining ring (4); refer to Power Steering
Pump Flow Control Valve Replacement - Off Vehicle (Regular).
Notice: Refer to Fastener Notice in Service Precautions.
7. Install the pump mounting studs (2) to the pump housing (1).