K Yukon/Denali 4WD V8-5.7L VIN R (2000)
14. Tighten the bolts in sequence to 11 Nm (97 inch lbs.).
15. Remove J25025.
16. Install the manual shaft detent roller and spring assembly (3) and bolts (2 and 4).
17. Install the two wiring harness clips (1) and bolts (2).
18. Install the wiring harness clip (1) and bolts (2).
19. Install the tube oil pipe (5) with the short end into the control valve body.
20. Install the lube oil pipe retainer (7) and the bolt (6).
Notice: Refer to Fastener Notice in Service Precautions.
21. Install the control valve body bolts.
Tighten the bolts sequentially to 11 Nm (97 inch lbs.).
22. Install the remaining control valve body bolts.
Tighten the remaining bolts to 11 Nm (97 inch lbs.).
