K Yukon/Denali 4WD V8-5.7L VIN R (2000)
7. If the bearing cup is not completely removed, do the following:
7.1.
Lift the cross and insert the J9522-5 between the seal and the bearing cup.
7.2.
Continue pressing the bearing cup out of the propeller shaft yoke.
8. Rotate the propeller shaft and press the opposite bearing cup out of the propeller shaft yoke.
Important: Production universal joints cannot be reassembled. There are no bearing retainer grooves in production bearing cups. Discard all
production universal joint parts that have been removed.
9. Remove the cross and the slip yoke from the propeller shaft yoke.
Important: Corrosion or dirt may prevent the bearing cup installation and may prohibit the proper seating of the bearing retainers.
10. Inspect the bearing cup bores for burrs or imperfections.
Installation Procedure
