K Yukon/Denali 4WD V8-5.7L VIN R (2000)
5. Remove the four bolts securing the transfer case shift control to the floor panel bracket.
Installation Procedure
Notice: Refer to Fastener Notice in Service Precautions.
1. Install the four bolts securing the transfer case shift control to the floor panel bracket.
Tighten the transfer case control bolts to 11 Nm (97 inch lbs.).
2. Install the shift lever end to the transfer case linkage rod.
Lower the vehicle.
3. Install the wiring harness to the transfer case shift control bezel.
