K Yukon/Denali 4WD V8-5.7L VIN R (2000)
Quarter Window Glass: Service and Repair
Quarter Window Replacement (Non Encapsulated)
Quarter Window Replacement
Removal Procedure
Tools Required
*
J 39032 Stationary Glass Removal Tool
*
Solvent for cleaning the edge of the window (use GM Glass Cleaner P/N 1050427 or isopropyl alcohol)
*
Household cartridge-type caulking gun
*
Commercial-type utility knife used to cut around the edge of the window
*
Rubber suction grips
1. Apply masking tape to the painted surfaces around the stationary window in order to prevent paint damage.
2. Use J 39032 in order to cut the window from the pinchweld flange. Do this from inside the vehicle.
3. Remove the stationary window from the pinchweld flange with the aid of an assistant.
4. Keep the blade of the knife as close to the pinchweld flange as possible in order to leave a base of urethane on the window.
5. The stationary window reveal molding retains the urethane adhesive in the cavity between the body and the opening. If the stationary window
reveal molding is damaged by cutting it too close to the window surface, replace the window.
6. Inspect the condition of the stationary window opening and the urethane adhesive bead to determine which installation method should be used.
Important: If corrosion of the pinchweld flange is present, or if sheet metal repairs or replacements are required, the pinchweld flange
must be refinished in order to present a clean primer only surface. If paint repairs are required, mask the flange bonding area prior to
applying the color coat in order to provide a clean primer only surface. Materials such as BASF DE17 (R), DuPont 2610 (R) and PPG
DP40 (R), or equivalent products are approved for this application.
7. After repairing the opening as indicated, perform the following steps:
